Where is the switch on a Mopar steering column?
Prior to tightening down the switch though, it’s imperative to lace the wire loom through the portal in the base of the hub, through the collar and between the two mounting bracket plates in the column. Year One suggests wrapping the loom with masking tape both at the terminals and half way down to keep the wires from being tangled.
How do you replace a light switch cover?
Remove the switch. Replace the cover with a blank wall plate cover, or put a blank insert in the existing cover where the light switch was. Screw the cover into place to cover up the hole in the wall. Then restore the power at the breaker box. If the light switch has more than two terminals, I recommend consulting an electrician.
How does the steering shaft go into the column?
Bottom left: The steering shaft slides into the bearing without trouble. Bottom center and right: The bearing can only go into the column one-way thanks to a key way. A pair of self-tapping screws secures it in place. Above: The collar slides on loosely and indexes counter-clockwise into a specific key way cut into the column.
How do you turn off a light switch?
Plug a light or better yet, a television or radio into the outlet, turn the power on, then flip breakers until the light or sound stops. If you use a light, you may need a helper. This is why I like to use something that emits sound, like a radio. Assuming a two-terminal switch: Remove the two black wires from the switch.
How do you remove a steering column from a Ford?
1. Disconnect battery cable. 2. Remove the horn pad by pulling it towards you—disconnect the electrical connectors 3. Remove the center bolt and remove the steering wheel. You may be able to remove it by wiggling it side to side (PUT THE BOLT BACK IN FIRST), otherwise, use a steering wheel puller
Why did my Mopar steering column need replacing?
In addition to the near-50-year-old plastic switch failing, several bits of brittle plastic needed replacing, including the tabs on the terminal connector and our rag joint. In all, the column itself was due for a restoration, and with the internet bereft of any worthwhile instructions on the matter, we felt it necessary to step up to the task.
Where can I buy parts for a broken steering column?
Our specialty is knowing what you might need and providing hard-to-find steering column parts for damaged or broken steering columns. With our full “STEERING COLUMN PARTS” inventory of the most commonly needed items on domestic vehicles, we make it easy for you to buy exactly what you need.
How many sets of instructions are there for replacing a steering column?
We have over 60 sets of STEP-BY-STEP instructions to help you repair any problem you might have with yoursteering column. Damaged steering columns from wear and tear or those just needing some special attention after years of service can be restored to fully functioning condition.