Where is the starter located in a 2008 Jeep Commander?
To access the starter you must remove the shield below the engine. The starter is a 4 to 5 inch diameter cylindrical assembly oriented longways, fore and aft. It will have 3 wires attached. 1 of the three is the battery cable [large diameter] It is attached at the junction of engine and transmission.
What does it mean when can Am Commander wont start?
To me that means when you turn the key it nothing happens when in the south east is means it wont start. So when you say it wont start, what is happening. You turn the key, press the start button and… nothing? turns over but wont run…?
What’s the problem with my Jeep Commander head lights?
For the past month my 06 commander head lights decide to turn on and off when they please. Along with the control panel lights dimming and brightening on their own. Not going over any bumps, does it whenever, no matter if heat, radio etc are on or off.
What happens when the a / C goes on on a Jeep Commander?
The rear assist lights come on, the auto high beam/low beam changes on the computer, the air bag light comes on & chimes. If the A/C is on, it goes from face to feet & back up.
How many miles on my can Am Commander?
I have put on roughly 140 miles on it and the last several times out periodically it wouldnt start.
To me that means when you turn the key it nothing happens when in the south east is means it wont start. So when you say it wont start, what is happening. You turn the key, press the start button and… nothing? turns over but wont run…?
I have put on roughly 140 miles on it and the last several times out periodically it wouldnt start.
What to do if your can Am wont start?
Yep got to be in park or neutral also check your fuel pump fuse ignition fuse to. Is the unit all stock? You do have it in park don’t you. Click to expand… pay attention to where you push the start button also..
Is the can Am Commander still under warranty?
Dude it should still be under warranty let the dealer figure it out you shouldn’t be having this problem. Clean your key and dielectric grease the key hole. This has been an issue when moisture is present.