Can you replace just the torque converter in a transmission?
The My 02 Malibu check engine light is on. The autostore guy put his code reader on it and said the torque convertoer is stuck in the off position. Will a flush and refill and new filter in the transmissi … read more
How do you replace a rear wheel drive transmission?
Easy to follow step by step guide on how to replace or remove an automotive manual (standard) transmission for rear wheel drive vehicles, though appearances may vary, the process is the same on most vehicles. Tools and Supplies Needed Hoist or hydraulic jack with stands.
What’s the best way to remove a transmission?
Begin with the vehicle lifted enough to access the transmission while using jack stands for safety, wear protective eyewear and gloves. Step 1 – Start by removing the negative battery cable end to help prevent electrical short circuits while the job is being done.
How do you reinstall a transmission in a car?
Step 44 – Reinstall the transmission mounting nuts and bolts. Step 45 – Reinstall the driveshaft by installing front mounting bolts, or sliding the spline into the transmission, finish by tightening the differential flange mounting bolts. Step 46 – Reinstall the exhaust system including gaskets and hangers.
What should I do before replacing my Clutch?
There will be several subsequent guides that will need to be performed before the clutch can be replaced which are listed below: 1. Remove the Clutch: Once the above jobs have been done it’s time to inspect and remove the clutch pressure plate.
How do you replace a clutch disc on a car?
With the clutch disc loose position and install the clutch alignment tool into the clutch disc and pilot bearing. Slightly tighten the bolts further to hold the disc in place and move the tool in a circular motion.
What happens when the last bolt is removed from a clutch?
As the last bolts are undone have an extra hand to control both the pressure plate and disc. The pressure plate will start to move outward from the flywheel as the the bolts are undone. While the last bolts are being removed keep your hands on the disc and plate to control these parts.
What should I do if my torque converter is bad?
As time goes on, the shifts will feel very hard and rough. The only way to reverse this is to make the output pressure of the torque converter better. This requires the engine’s RPM to be higher.