How to decelerate a General Motors OBDII drive cycle?
Decelerate with using the brake [or the clutch!] by coasting down to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute. General Motors (specific) OBD II Drive Cycle Performing a GM OBDII Driving cycle: Cold Start.
How to reset the OBD II drive cycle?
Decelerate without using the brake (coast down) to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute. Restart and accelerate to 40-55 MPH at 25% throttle and maintain speed for two minutes.
What do you call the drive cycle after an OBD test?
This is commonly referred to as a “drive cycle.” If possible, when working on a vehicle either before or after an E-Check OBD II test; do notclear the Diagnostic Trouble Codes (DTC’s) so that the check engine light remains on after the repair(s).
What’s the drive cycle procedure for a Chrysler?
Driving Procedure : 1) Warm engine up for five minutes (must reach closed loop) 2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes. 4) Drive (with steady throttle) at a speed above 20 mph for 2 minutes.
Decelerate with using the brake [or the clutch!] by coasting down to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute. General Motors (specific) OBD II Drive Cycle Performing a GM OBDII Driving cycle: Cold Start.
Decelerate without using the brake (coast down) to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute. Restart and accelerate to 40-55 MPH at 25% throttle and maintain speed for two minutes.
This is commonly referred to as a “drive cycle.” If possible, when working on a vehicle either before or after an E-Check OBD II test; do notclear the Diagnostic Trouble Codes (DTC’s) so that the check engine light remains on after the repair(s).
What do you need to know about OBD pre conditioning?
Chrysler & Dodge: Drive Cycle Procedures to complete OBD Readiness Monitors. Pre-Conditioning Requirements: 2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes. 4) Drive (with steady throttle) at a speed above 20 mph for 2 minutes.