Why is the ignition switch on my Jeep not working?
Sometimes Jeeps won’t start but all the electronics work. It might be a faulty ignition switch keeping your Jeep from starting. This video is a how-to for replacing the Start Ignition Switch Actuator Pin; a known weakness in our beloved Jeeps. If you aren’t sure why your Jeep won’t start, this probably IS NOT your issue because it is rare.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
How do you remove a battery from an ignition switch?
Use an appropriate sized wrench to loosen the nut holding the cable on the negative (-) terminal and then slide it off the post. You don’t need to remove the positive cable from its terminal. Tuck the negative cable to the side of the battery to make sure it doesn’t accidentally come into contact with the terminals.
What happens when the ignition switch goes bad?
Have u checked the igniction switch actuatior pin. It’s a bad design realty weak Click to expand… When the actuator switch goes bad, does the little light with the key and a line through it come on when you turn the key? Sound like the wife was driving the Jeep..
How do you change the ignition on a jeep?
Insert the ignition key into the cylinder lock and turn it to the “Start” position. Locate the cylinder lock pin on the side of the switch and press the pin in with a flat-head screwdriver. Pull the lock cylinder out of the switch about 1/2 an inch. Remove the key and pull the lock cylinder completely out of the switch.
Sometimes Jeeps won’t start but all the electronics work. It might be a faulty ignition switch keeping your Jeep from starting. This video is a how-to for replacing the Start Ignition Switch Actuator Pin; a known weakness in our beloved Jeeps. If you aren’t sure why your Jeep won’t start, this probably IS NOT your issue because it is rare.
How can I tell if my ignition switch is working?
Test the Ignition Switch With the key in the RUN or ACC position, see if you are getting power to fuses 5, 8, 10, and 14. If you aren’t getting power there, check fuse 18 and see if it’s good. If it’s good, then check for power at pin 1 (red), 7 (red), 3 (pink/black) and 2 (gray/dark blue).
How do you remove the ignition switch from a car?
Remove the ignition switch. Unscrew the bolts on both sides of the ignition that hold it in place with a ratchet and socket. Use your hand to pull the ignition switch from the actuator rod. The actuator rod is what holds the ignition switch to the base of the steering wheel. Release and remove the switch completely from the steering wheel base.