Why does my Jeep shut off after remote start?
40 people found this helpful. In the instruction manual it states under certain circumstances the engine will shut off when you use the remote starter. My 08 GC did the same thing because the ” check engine” light was on.
How long does it take for Jeep remote to start?
On my remote start feature, everything works but for only 10 seconds then turns off. Jeep starts fine when I insert the key. What am i missing? is your remote a factory or an aftermarket ??
Why is my Jeep Grand Cherokee stalling out?
@cardoc3 This is what my local Jeep dealer said after working on it for 2 1/2 days. They even replaced the coils, to no avail. BROUGHT IN HER 2006 JEEP GRAND CHEROKEE with 53,280 MILES WITH IT STALLING OUT AT STRT UP CODES IN SYSTEM TCM PO882 TCM POWER INPUT LOW]
What happens when you turn off service 4 wheel drive?
The radio stays on, the heater etc. When it dies there is no sputtering etc. is like someone just turned the key off. We have tried reviving the RPM’s up, putting in gear, but it continues to shut off. The only thing that pops up in the dash is service 4 wheel drive.
Why does my Jeep start and then turn off?
When normally starting the Jeep, if you stop at turning the key to on, you should see the red Security Key light go out. Sometimes it is only one key. If both key react that way, it is most likely the module (separate from the remote lock/unlock module) which I believe is mounted to the steering column under the dash.
What happens when you start your Jeep Cherokee?
When I start my jeep, it starts clean, but only runs for about two seconds before shutting off. In addition, the electronics on the dash are not working. Hello.
How to stop a Jeep Grand Cherokee from stalling?
First, turn the key off, get out of the car, then turn on alarm/security, which should lock the car door. Wait 2 minutes, unlock the security control with the key fob, get in, and try restarting the Jeep. If this doesn’t work, disconnect the negative battery cable for 5 minutes, then reconnect it.
Where is the red light on a Jeep Wrangler?
Thank you. With either key, turn the key to on (not start) and while the cluster is going through the self test, keep an eye on the little red light at the far right of the console (above and to the right of the temp gauge). After about three seconds that should go off.