How to replace ignition distributor in Jeep Grand Cherokee?
9. Rotor, cap, connections Now install the rotor, then the cap and distributor connector. Then using previously made notes correctly connect all ignition cables. 10. Fan Reinstall the auxiliary fan and connect negative battery cable. Start engine. Take a beer. Technorati Tags: Jeep, Cherokee, XJ, Grand Cherokee, ZJ, distributor, rotor, cap
Where can I find a Jeep dealership near me?
Please provide us with your ZIP Code to find the dealers closest to you. There is no inventory data currently available. There are no local dealers near ZIP Code 60601. Please ensure that your ZIP Code is entered correctly.
How to replace oil pump distributor in Jeep?
Before inserting new distributor in it’s place you need to make some alignment. First, using flat screwdriver, set the oil pump shaft around 11 o’clock position: 7. New distributor preparation Then take the new distributor, put the old cap on it and mark the distributor next to the number one cylinder terminal as you did with the old one.
9. Rotor, cap, connections Now install the rotor, then the cap and distributor connector. Then using previously made notes correctly connect all ignition cables. 10. Fan Reinstall the auxiliary fan and connect negative battery cable. Start engine. Take a beer. Technorati Tags: Jeep, Cherokee, XJ, Grand Cherokee, ZJ, distributor, rotor, cap
How to change oil pump on Jeep 4.0L?
First, using flat screwdriver, set the oil pump shaft around 11 o’clock position: 7. New distributor preparation Then take the new distributor, put the old cap on it and mark the distributor next to the number one cylinder terminal as you did with the old one. Then set distributor’s shaft in a way that rotor’s line should point on 4 o’clock. 8.
Where are spark plugs made for Jeep Wrangler?
Like BFG and their American made BFG tires that aren’t made in France by Michelin who owns BFG, Autolite’s spark plugs are made right here in the U.S. in the same Autolite plant and workers who were there before they were bought by Allied Signal. Don’t put Autolite plugs in your Jeep.
Do you need to turn crankshaft vibration damper on Jeep Grand Cherokee?
This step is only necessary when procedure is done on the Cherokee (XJ) model – this is the only way to turn the crankshaft vibration damper. In Grand Cherokee (ZJ) you have access to this bolt from underneath.
How to test ignition coil in Jeep Wrangler?
It can save you lots of headache and money knowing how to do it. You don’t need any fancy tools to test a Jeep ignition coil. All you need is a simple multi-meter and a 12-volt test light. So, with those two simple tools and about 15 minutes can answer a few vital diagnostic questions for your ailing Wrangler or Cherokee.
How can I tell if my ignition coil has a weak spark?
If you have a weak spark coming from the spark plug, lets check the ignition input voltage first. On the plug there is a green and a white wire. The White wire is a 12 volt constant. Turn the key to ignition on/run (no need to try to start it).
What does it mean when your ignition coil is orange?
If the spark is orange or some similar color. Either the coil is weak and is going bad or you do not have proper voltage going into the coil. If you have a weak spark coming from the spark plug, lets check the ignition input voltage first. On the plug there is a green and a white wire.
When did the distributor come out on the Jeep Grand Cherokee?
Jeep introduced the Grand Cherokee in 1993, and engines from then until 2000 contained distributors. The 2.5L and 4.0L engines had distributors all through those years, with the 5.2L and 5.9L joining the group from 1993 to 1998. If you’re handy with some basic tools, you can replace the distributor.