Where are the ball joints and tie rods located?
Both ball joints and tie rod ends are each a part of the front suspension and steering system of your car and are located between the front wheels. The steering system spans the entire length between the front wheels, connecting the two wheels together, while the suspension system is contained just inside each front wheel.
How do you replace an outer tie rod?
Move the pinch nut up to touch the outer tie rod end. This will mark the location of your outer tie rod end and you will know how far to thread on the replacement. Do not tighten the pinch nut. If you do, you will not be able to easily turn the outer tie rod end. Remove the cotter pin.
How much does it cost to replace a ball joint on a jeep?
For a 2000 Jeep Grand Cherokee four wheel drive, which uses a solid front axle, the labor time to replace the upper and lower ball joints on one front corner is 1.9 hours. A factory pair costs about $150, and a pair of Delphi ball joints costs about $63.
Where are the tie rod ends on a car?
Locate the outer tie rod end. When you remove the wheel, you will be able to see the steering knuckle. There will be a shaft going through this knuckle with a castle nut on the bottom and a round head on top. This is the outer tie rod. Locate the inner tie rod end. Cars often have an inner tie rod end as well.
Why do you need ball joints and tie rod ends?
This kit from Whiteline includes extended ball joints and outer tie rod ends to move the pivot point of both suspension components to correct for the change in ride height. When a vehicle is lowered, the angle of the tie rods and lower control arm can add more body roll in addition to the undesirable bump-steer feedback in the steering wheel.
How to tighten and torque tie rod ends?
Tighten and torque the ball joint and tie rod end components to the manufacturers specified torque ratings, which can be found with some research. We reattached the sway bar, which we removed earlier to move the control arms. Double-check that everything is tightened and torqued.
What do you need to remove lower ball joint?
Removing the front sway bar end links allows the control arms to move independently, which gave us the movement in the control arm we needed to remove the lower ball joint. The outer tie rod is connected to the spindle using a castle-type nut. A cotter pin holds the castle nut in place and must be removed before the 19 mm nut can be removed.
What should I use to replace my tie rod?
Once the tie rod is loose, you should be able to spin it off freely and replace it with the Whiteline replacement tie rod end. Try to get it close to the same location as the original tie rod. We locked the tie rod end into place using the lock nut and manufacturer’s torque rating.