What does the fan belt on a jeep do?

This belt is also known as the “accessory belt” or “fan belt” and it is a way to transfer power from the rotating crankshaft to drive necessities/accessories such as: Alternator (for charging the battery and keeping your electrical system running)

How do you remove a serpentine belt from a jeep?

While the tension is removed from the belt, pull the belt towards the front of the vehicle (shown by green arrow below) and slip it off of the tensioner. If you have difficulty slipping the belt off of the tensioner, try to slide it off of one of the many other pulleys instead. Step 4 Now you can release pressure on the tensioner.

When did serpentine belts start to replace fan belts?

Fan belts are more commonly found in vehicles built before the 1990’s when serpentine belts started to replace them. In theses older models, “fan belts” are usually paired with other belts that together form a “V” shape around your drive pulleys and gears.

When do you know it’s time to replace your fan belt?

If you find your fan belt is no longer attached to your engine, or is lying on the ground somewhere, that is definitely a sign that it’s time to replace your fan belt! When experienced individually, these signs do not always indicate that your fan belt or serpentine belt needs to be replaced.

How do you change the belt on a jeep?

As you are standing at the front of your Jeep facing to the rear, you want to use your wrench/bar to rotate the belt-tensioner arm clockwise (depicted by blue arrow below); this will be towards the ground in most cases. This removes the tension from the belt.

What does the serpentine belt on a jeep do?

What should I use to replace timing belt on Jeep Liberty?

Other: Zerex G-05 coolant, about 1.3 gallons lost during the procedure. Serpentine belt. Serpentine belt tensioner. Fan clutch. Alternator/decoupler. JB weld (for intercooler leaks). There are aftermarket alternatives available.

How do you replace a belt on a Jeep Grand Cherokee?

Check the belt routing so you know how to replace the belt. You may be able to find a belt routing diagram on a decal on the fan shroud or in support documentation. Otherwise, make you own sketch for reference. Rotate the belt tensioner pulley, using the wrench, to and relieve tension on the belt.

How do you change the timing belt on a jeep?

1. Remove the air cleaner upper cover, housing and clean air tube. 2. Raise the vehicle on a hoist. 3. Remove the accessory drive belts. 4. Remove the crankshaft vibration dampener. 5. Remove the air conditioner/generator belt tensioner and pulley assembly. 6. Remove the timing belt lower front cover bolts and the cover.

How do you change the belt tension on a Jeep Grand Cherokee?

For some older 6-cylinder models, the belt tension system is different. On these models, change the tension on the belt by loosening the two power steering bolts on the side of the power steering pump, then turn the adjustment bolt below the pump counter-clockwise to release tension on the belt.

Where to find belt routing diagram on Jeep?

Now, locate your “Belt Routing” diagram, which is a decal that should be affixed to the top of the radiator or on the sheet metal under the hood somewhere quite visible. After finding the routing decal, locate belt tensioner.

What kind of fan shroud for Jeep Cherokee XJ?

Mishimoto MMFS-CHE-68 Silver Aluminum Performance Fan Shroud.mishimoto Rendimiento Ventilador Sud… Mishimoto MMFS-E46-99NPT Black Performance Fan Shroud Kit.mishimoto mmfs-e46–99NPT Negro Rendimie… Pages with related products.

How do you change the belt on a water pump?

Use your belt routing diagram to put the new belt onto all of the pulleys. Pay close attention to the water pump pulley, as incorrect routing can cause the water pump to run backwards and overheat. Make sure the belt is correctly routed and seated on all pulleys.

Navigation