What is the p0335 code on a Jeep Patriot?
I pulled a P0335 code which is the Crankshaft position sensor and went ahead and replaced it. That was the only error code involved. After replacing the Jeep still will not start. Does anybody have any thoughts on this?
What does the p0340 Jeep camshaft position sensor do?
P0340 JEEP Description. The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection.
When does the p0335 crankshaft position sensor a circuit?
If the PCM detects that there are no crankshaft pulses or if it sees a problem with the pulses on the output circuit, P0335 Jeep will set. NOTE: If the crank sensor is used only for misfire detection and NOT spark timing (this varies with the vehicle), the vehicle should start and run with MIL (Malfunction indicator lamp) illumination.
What causes a p0335 check engine light to not work?
If the crank sensor is used for BOTH misfire detection and spark timing, the vehicle may or may not start. Symptoms may include: Vehicle may not start (see above) Vehicle may run rough or misfire A P0335 “check engine light” code could be caused by: Damaged CKP sensor connector
Is the p0339 Cam and crankshaft sensor code?
Yes at an Authorized Jeep Dealership. They said the P0339 was the sensors code. They took it upon themselves to replace the cam and crankshaft sensors. Doing Solenoid because they suspect the timing is off…? v Lets get the details and gather info then get some info posted.
What’s the difference between p0335 and p0385?
This code is basically identical to P0385. This code P0335 refers to Crankshaft Posistion Sensor “A”, whereas P0385 refers to Crankshaft Position Sensor “B”. Other crank sensor codes include P0016, P0017, P0018, P0019, P0335, P0336, P0337, P0338, P0339, P0385, P0386, P0387, P0388, and P0389. my truck is not getting any throttle…
What causes a low crankshaft position sensor code?
Sometimes and in some models, low battery voltage or a weak starter can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replaced battery.
If the crank sensor is used for BOTH misfire detection and spark timing, the vehicle may or may not start. Symptoms may include: Vehicle may not start (see above) Vehicle may run rough or misfire A P0335 “check engine light” code could be caused by: Damaged CKP sensor connector