Is there an error code for cylinder 2?
Specifications in definition, troubleshooting and repairs vary from one make and/or model to another. This code is very similar to P0200, P0201, P0203, P0204, P0205, P0206, P0207, and P0208. Additionally, this code can be seen in engine misfires, as well as with rich and lean conditions.
What causes a cylinder 2 fuel injector to malfunction?
Defective cylinder 2 fuel injector Plugged or dirt in fuel injector Corroded fuel injector, connections or wiring Poor or broken electrical connections in the connector or harness Open or short wiring harness for the cylinder 2 injector circuit Defective fuel injector power circuits
Where do DTCs go when the IDM detects a fault?
When the IDM detects a fault, DTCs are transmitted over the CAN2 data link to the ECM. The IDM transmits a high and low side drive output to the injectors.
How to clear diagnostic trouble codes ( USA only )?
How to Clear Diagnostic Trouble Codes CLEARING FAULT CODES (USA only) When a fault has been corrected, the fault code must be cleared. This is done by performing the following procedure: Put the ignition switch in position II. Disconnect the Data Link Connector (DLC) , which is located behind R/H side of dash, and wait 5 seconds.
What is the trouble code for cylinder 2?
The P0202 code is a general OBD-II diagnostic trouble code (DTC) associated with the injector circuit. Note: This code may be seen with P0200, P0201, or P0203-P0212. P0202 may also be seen with misfire codes and lean or rich condition codes. P0202 indicates that the ECM has detected a malfunction for the cylinder 2 injector circuit.
What is the code for cylinder 4 injector circuit?
P0204 tells technicians a malfunction was found for cylinder 4 injector circuit. This code is similar to P0200 – P0203, and P0205 – P02012.
What is the PCM code for cylinder 6?
This code is very similar to P0200, P0201, P0202, P0203, P0204, P0205, P0207, and P0208. Additionally, this code can be seen in engine misfire, rich and lean conditions. The PCM works by monitoring the injector, and when the latter is activated, it determines whether the voltage pulled “low” or close to zero.
What does trouble code p0206 mean on cylinder 6?
This code means the PCM (powertrain control module, also known as ECM or engine control module in other makes) has found a problem with the injector or its wiring, or in injector circuit for cylinder 6. This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II, or vehicles made in 1996 to present.