Why does my tire pressure sensor keep flashing?
Tire pressure sensors often use a battery, and a flashing TPMS warning light can often be a sign that the battery is close to dying. It may also indicate a problem with one of the sensors. Either way, working on tire pressure sensors or replacing the tire pressure sensor battery is a touch more difficult than regular maintenance.
How to reset a blinking tire pressure light?
1 Put your vehicle key in the ignition to turn the battery on. 2 Push the TPMS reset button until you see a flashing tire pressure light, which usually appears after approximately three seconds. 3 Start your vehicle. 4 Drive for about 20 to 25 minutes. 5 Turn your car’s ignition off.
Where is the reset button on the tire pressure sensor?
Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The TPMS reset button is usually located beneath the steering wheel.
What does low tire pressure sensor fault mean?
Low Tire Pressure In some car models, the tire pressure sensor fault light can also mean low tire pressure in your car. Inflating your car is pretty easy, and if you do not know how to do it – you can go to any workshop or fuel station and let it do for you.
How much does it cost to replace a tire pressure sensor?
The parts cost, often less than $25, when added to minimum labor shop costs, greatly depend on the geographical region, can bring the grand total to about $75 to $125 per wheel to have the sensor swapped out and replaced.
How do you reset the tire pressure sensor?
How to Reset Tire Pressure Sensor 1. Identify the type of TPMS 2. Get your Tires Inflated 3. Monitor the Battery 4. Readjust the Transponders 5. Make Use of Magnet method 6. Utilize the Scan Tool Method
Why is my TPMS light flashing?
Faulty TPMS is another common reason for TPMS warning light flashing, but the cause may not be so obvious. On direct-TPMS systems, this may indicate a dead TPMS sensor battery, faulty TPMS sensor, or a faulty TPMS module.
What to do when the tire pressure light is flashing?
For most cars, all you need to do are the following: Put your vehicle key in the ignition to turn the battery on. Push the TPMS reset button until you see a flashing tire pressure light, which usually appears after approximately three seconds. Start your vehicle. Drive for about 20 to 25 minutes. Turn your car’s ignition off.