Can a plug and play brake controller be installed?
The Elecbrake plug and play version allows a fully featured proportional electric brake controller to be installed on your trailer and ready to go within 10 minutes Using the plug and play version of the elecbrakes is a fuss free option saving you time and money of a full install, without compromising on functionality or capabilities.
How to remove an electronic brake control module?
Step 2: Remove engine cover and air filter housing. In many instances you’ll have to remove the engine cover and air filter housing in order to have free access to remove the electronic brake control module. Refer to your service manual for exact instructions on how to remove these components.
What kind of sensor does elecbrakes brake controller use?
Elecbrakes employs a high-speed microprocessor and various sensors which continuously sample the operating parameters over 1,000 times per second.
Where do I plug in a brake controller?
The brake control adapter is plugged into the second slot from the left on the top row. Hardwire the open wires of the brake control adapter to the wires on the brake controller. Plug the other end of the adapter into the electrical junction box (see above). Mount the brake controller in a place that is easily accessible.
Where is the trailer brake controller located on a Chevy Silverado?
Set the controller into the bracket at your desired position and drill screws into the side of the controller body (refer to your controller’s instructions for the specific location). Figure 1. Mounted trailer brake controller. This junction box is located behind the brake pedal at the left corner of the floorboard area.
How to install a brake controller on Chevrolet / GMC 1999?
Hardwire the open wires of the brake control adapter to the wires on the brake controller. Plug the other end of the adapter into the electrical junction box (see above). Mount the brake controller in a place that is easily accessible. A: Remove the bracket in the corner closest to the driver. B: Remove the top cover of the “Accessory Fuse Block”.
Where is the junction box for a brake controller?
The manufacturer provides a brake control adapter that connects to the brake controller and plugs into the vehicle’s electrical junction box. This junction box (shown below) is located on the driver’s side below the dash, left of the brake pedal.