How do you shift a 2000 Jeep Wrangler into 4WD?
Stop your Jeep and put the gear shift selector in “N” (Neutral). Keep your foot applied to the brake pedal. Move the 4WD shift selector straight down to 4H (from 2H). Move the gear selector back to “D” (Drive) and continue driving.
How do you put a Jeep Wrangler in 4 wheel drive?
From here, engage the gear shift selector in “N” (Neutral). While at i4H to 4L or 4L to 4H, keep the foot pedal firmly on the brake pedal. From here, you can now move your shift selector to your require gear position. Once you’re done, move the gear selector back to “D” (Drive) and continue driving.
How do you change from 4WD to 4L in a jeep?
Release the brake pedal and allow the Jeep to coast (do not apply the gas pedal) at a low speed, preferably 2 to 3 miles-per-hour. Change the 4WD selector from 4H to 4L quickly, without pausing in the “N” position between the two gears.
When to switch from 2H to 4h in a Jeep Wrangler?
Switching from 2H to 4H is important when the ground/road is slippery, wet, or just loose. You would need to switch to a full 4WD. All you need to do is pull the vehicle’s lever firmly but slowly. This helps you to swap to 4 Hi. In case you want maximum traction, then you would need to put the Wrangler to the 4 Low.
What should be the speed of a 4 wheel drive Jeep Wrangler?
Go from 2H to 4H and then put it on neutral to go all the way to 4L. When you are driving with 4L, you should not exceed the speed. Keep it less than 25mph. For 4H, the recommended speed is 45-50 mph.
How to put a Jeep Wrangler in 4 wheel drive?
The Jeep Wrangler and Jeep Gladiator have the 2 Wheel Drive Part-time System. To put them into 4 Wheel Drive High you need to be drive around 7 – 30mph and pull down the lever from 2H to 4H. If you need to put them into 4 Wheel Drive Low you need to be Parked and then shift into Neutral. Then you will pull the lever down from 2H to 4L.
Release the brake pedal and allow the Jeep to coast (do not apply the gas pedal) at a low speed, preferably 2 to 3 miles-per-hour. Change the 4WD selector from 4H to 4L quickly, without pausing in the “N” position between the two gears.
How do you shift from 4h to 2H in a Jeep Wrangler?
The procedure to shift from 4H back to 2H is a straight forward simple one. You need to once again ensure you are driving straight with no heavy load on the vehicle drivetrain. Gently lift your foot off the gas pedal and depress the clutch if it’s a manual.
How do you change gears in a Jeep Wrangler?
Stop your Jeep To change the gears, first, stop your Jeep. From here, engage the gear shift selector in “N” (Neutral). While at i4H to 4L or 4L to 4H, keep the foot pedal firmly on the brake pedal. From here, you can now move your shift selector to your require gear position.